Just setting up mine, bought from a friend. The manual PLAINLY says "Install the reflector glass by sliding it over the two side clips and rear clip. Make sure the letter "H" dot pattern on the glass runs as shown and is on the bottom side of the glass". Well there is no letter H or dot there may have been during the first set up. The glass itself does say "safety glass" so I can tell one side from the other.
Anyone know how to position the glass? It might matter alot, I have no idea. I'm hopeful someone will know.
Thanks for this!
Edurrill,
My great thanks for posting the pdf. It's clear that what I've got is a replacement piece of glass, I can plainly see that I don't have the "H". I suppose that was to even out the light element.
Any suggestion on that? At any rate the pdf manual was mighty fine.
Thanks again,
redbird