Re: Threaded Discussion or Flat View - Your Choice.
It should be noted that this software is different than our old forum in this major way. The old forum could only be viewed as a thread if I recall rightly. Therefore it was always clear to whom you were replying.
In this software you can view it "flat" or threaded. This may seem confusing to some until we get the hang of it.
I would suggest that everyone use the "threaded" view to figure out who is talking to whom about what. (Large button located on the upper right corner of your display shifts between the two views.)
cwr.provost (at) yahoo.com
<until further notice>